"Out of Band" below VFO Frequency

Installation questions, Setup, and general information not covered in the other sub-forums
Post Reply
pwest
Posts: 14
Joined: Sun Nov 29, 2020 2:00 pm

"Out of Band" below VFO Frequency

Post by pwest »

Hello all:
Yesterday when I fired up PowerSDR )(with my Flex-1500), it complained that the database was corrupted. I let it load the last good copy, and all seems fine except the band indicator below the VFO frequency always (at least for all bands/freqs I've tried) now indicates "Out of Band". I tried to use the 'repair' function of the installer but this seemingly had no impact.

Any ideas for getting this fixed would be appreciated!

Thanks,
Phil
User avatar
ke9ns
Site Admin
Posts: 515
Joined: Mon Nov 05, 2018 9:38 am
Location: Illinois, North West Suburbs
Contact:

Re: "Out of Band" below VFO Frequency

Post by ke9ns »

Take a photo of the full PowerSDR console when this happens, so I can see everything.
Darrin
Creator of PowerSDR KE9NS v2.8, based on the Flex Radio PowerSDR v2.7.2 software.
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
pwest
Posts: 14
Joined: Sun Nov 29, 2020 2:00 pm

Re: "Out of Band" below VFO Frequency

Post by pwest »

Here's a pic. I've tried changing bands and scanning around within bands, but 'Out of Band' persists. Otherwise all is working well (as usual).
PowerSDR_OutOfBand.PNG
PowerSDR_OutOfBand.PNG (1.27 MiB) Viewed 20402 times
Thanks,
Phil
User avatar
ke9ns
Site Admin
Posts: 515
Joined: Mon Nov 05, 2018 9:38 am
Location: Illinois, North West Suburbs
Contact:

Re: "Out of Band" below VFO Frequency

Post by ke9ns »

Try doing setup->factory defaults.
Then see if it clears up before trying to put back a "backup"

Darrin
Creator of PowerSDR KE9NS v2.8, based on the Flex Radio PowerSDR v2.7.2 software.
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
pwest
Posts: 14
Joined: Sun Nov 29, 2020 2:00 pm

Re: "Out of Band" below VFO Frequency

Post by pwest »

This worked!

Many thanks,
Phil
Post Reply