PowerSDR KE9NS v2.8

Darrin, I encountered a problem when I selected the "SPEC" mode. Both RX1 and RX2 displays turned all white with a red X across the screen with a error message indicating "an unhandled exception has occurred in the application. Index was outside the bounds of the array." I quit t...

Thank you Darrin and IK8HCG!

The update worked flawlessly. I did not have to import the backup database.

Forgot to mention I am using a Flex 5000

Darrin,
Can I update from v2.8.0.194 to v2.8.0.306 directly without any problems?

I am using an HP Z440, 64 bit with Xeon CPU E5-1650 v4 @3.6 GHZ

Windows 10 Pro for WS, version 22H2

Thank you

Jerry

Bob,

Thank you for the tip. I was able to get it set so I can grab the line. It is better and I can move the line up and down now although it is still a little bit unstable.

Jerry

Darrin, I have been using the AGC-T line function you created and this is very helpful and fun to use. It works well on HF but I noticed when working on 2m and 70cm I can use the hand and grab the line to move the AGC-T line toward the top of the screen but when I try to grab the line to move it tow...

Darrin,

Does the memory interface and scanner work with RX2? I can't find a selection for RX2 but not sure if I am setting the interfaces up correctly.

Thank you
Jerry

Darrin,

Thank you for the assistance!

Jerry

Darrin, I am runnning v2.8.0.185. When I start up PSDR the display always starts with the Map. I can turn it off by clicking the map button on the menu but when I shut down PSDR and restart it comes up with the map again. In the past PSDR would start up with the same settings it had when I shut down...

Darrin,

I did a reset and RX2 is working fine now. I also installed v2.8.0.109 and the RX2 Panadapter display works great when RX1 Waterfall display selected.

Thank you very much!!

Jerry

Darrin, I noticed the RX2 antenna input goes away when RX2 is tuned to any other band than RX1. I have two separate antennas connected to RX1 and RX2 but the antenna signal goes away on RX2 if I try to monitor a different band than the band RX1 is tuned to. I have the antenna form set to "Simpl...

Darrin, Should the panafall mode function independent of the mode selection on RX1? Panafall on RX2 doesn't function unless panafall is selected on RX1 at the same time. I also noticed when RX1 is in waterfall mode and RX2 is in panadapter mode, the RX2 display is jerky. Do I have something set up i...

Darrin- Thank you

I am seeing PSDR freeze ups occasionally but with the DttSP Auto Restart box checked the DttSP Restart counter stays at zero. A manual Stop/Start of the PSDR starts PSDR running normally again.

What is the purpose of the box with the number 0 in it to the right of the DTTSP Auto Restart in the PowerSDR Setup/General/Hardware Config screen?