Page 1 of 1
Suggestion
Posted: Sat Apr 18, 2020 7:01 pm
by artdriggers
It would be nice to have SWR plot information stored as a spreadsheet or text file.
Re: Suggestion
Posted: Mon Apr 20, 2020 12:16 pm
by ke9ns
I will take a look at doing that.
Darrin ke9ns
Re: Suggestion
Posted: Tue Apr 21, 2020 9:13 am
by G7DAZ
Hi Darrin, any chance od an "extra" set of band-buttons for the 2nd receiver instead of the drop-down box (lower left)...i now have widescreen monitors lol; so i can now display the meters on top etc and it looks like there might be a "little real-estate" above the 2nd rx mode/filter-width buttons or inbetween them both ?
Re: Suggestion
Posted: Fri May 08, 2020 8:24 am
by W2ASC
I was just trying (unsuccessfully) to open the "ke9ns_SWR1.dat" file to compare readings taken via the radio vs those taken with an analyzer at the antenna feed point. Since I couldn't figure out how to open the file, I searched the forum for info and came across artdriggers suggestion to have a way to save SWR as a text file. I definitely second the request. I think it would be very useful. Please consider it if its not too much trouble.
Re: Suggestion
Posted: Mon May 11, 2020 1:38 pm
by ke9ns
With .166 there is now a SWR_PLOTS folder, and every SWR run you make creates a .csv spread sheet file of the SWR.
Right click on the SWR SCAN button to open the folder.
Darrin ke9ns.com
Re: Suggestion
Posted: Wed May 13, 2020 5:49 am
by W2ASC
Outstanding! Thank you Darrin!