ATU does not tune antenna.

General Info for PowerSDR KE9NS v2.8 (for the SDR-1000, Flex-1500, Flex-3000, and Flex-5000 only).
Post Reply
ve3eib
Posts: 1
Joined: Tue Apr 23, 2019 3:16 pm
Location: Cambridge, ON
Contact:

ATU does not tune antenna.

Post by ve3eib »

After upgrading to versions .182 and .183 with Flex-3000. The ATU button is enabled but when pressed it does not go into transmit mode. However, the Tuning Progress bar comes up and turns green. Does this on all bands and all modes. Pulser is off. Pressing the Tune button, the transmitter is activated and there is output power.
User avatar
ke9ns
Site Admin
Posts: 524
Joined: Mon Nov 05, 2018 9:38 am
Location: Illinois, North West Suburbs
Contact:

Re: ATU does not tune antenna.

Post by ke9ns »

Nothing related to the ATU was touched in many version changes, but sometimes the database takes a hit after I make updates.

Open the ATU window. Try do a "Reset ATU database"? Otherwise you may need to then do a setup->factory defaults.

Then if you made a database backup, try a setup->import database

Darrin
ke9ns
Creator of PowerSDR KE9NS v2.8, based on the Flex Radio PowerSDR v2.7.2 software.
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
Post Reply