ATU does not tune antenna.
ATU does not tune antenna.
After upgrading to versions .182 and .183 with Flex-3000. The ATU button is enabled but when pressed it does not go into transmit mode. However, the Tuning Progress bar comes up and turns green. Does this on all bands and all modes. Pulser is off. Pressing the Tune button, the transmitter is activated and there is output power.
-
ke9ns
- Site Admin
- Posts: 524
- Joined: Mon Nov 05, 2018 9:38 am
- Location: Illinois, North West Suburbs
- Contact:
Re: ATU does not tune antenna.
Nothing related to the ATU was touched in many version changes, but sometimes the database takes a hit after I make updates.
Open the ATU window. Try do a "Reset ATU database"? Otherwise you may need to then do a setup->factory defaults.
Then if you made a database backup, try a setup->import database
Darrin
ke9ns
Open the ATU window. Try do a "Reset ATU database"? Otherwise you may need to then do a setup->factory defaults.
Then if you made a database backup, try a setup->import database
Darrin
ke9ns
Creator of PowerSDR KE9NS v2.8, based on the Flex Radio PowerSDR v2.7.2 software.
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior