Cannot use PowerSDR v2.8 after
-
antennadad
- Posts: 2
- Joined: Sat Dec 22, 2018 10:21 pm
- Location: NE Ohio
Cannot use PowerSDR v2.8 after
Hello Folks, I just downloaded .108 and did Firmware Update and now I cannot run the program. Tried rebooting. Same. I snipped the fatal error and it is attached. I am running Windows 10 Pro. Any ideas? Thanks, Rod
- Attachments
-
- Fatal Error.JPG (104.36 KiB) Viewed 10354 times
-
ke9ns
- Site Admin
- Posts: 524
- Joined: Mon Nov 05, 2018 9:38 am
- Location: Illinois, North West Suburbs
- Contact:
Re: Cannot use PowerSDR v2.8 after
That is a database corruption. It can happen when you upgrade from one version to a newer version.
go to folder: %userprofile%\AppData\Roaming\FlexRadio Systems\PowerSDR v2.8.0\
and remove all the files with your radios matching serial number. (there are usually 5 files: 1 main and 4 backups)
Now when you launch PowerSDR it will create a new factory defaults database.
If you previously made a backup database (i.e. setup->export database), you can try to load it in (setup->import database).
Darrin ke9ns
go to folder: %userprofile%\AppData\Roaming\FlexRadio Systems\PowerSDR v2.8.0\
and remove all the files with your radios matching serial number. (there are usually 5 files: 1 main and 4 backups)
Now when you launch PowerSDR it will create a new factory defaults database.
If you previously made a backup database (i.e. setup->export database), you can try to load it in (setup->import database).
Darrin ke9ns
Creator of PowerSDR KE9NS v2.8, based on the Flex Radio PowerSDR v2.7.2 software.
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
-
antennadad
- Posts: 2
- Joined: Sat Dec 22, 2018 10:21 pm
- Location: NE Ohio
Re: Cannot use PowerSDR v2.8 after
Thanks for the reply.
I was unable to locate that string, so I uninstalled and reinstalled .107 to start over. I think the databases files were running out of a old, improperly named folder.
73,
Rod
I was unable to locate that string, so I uninstalled and reinstalled .107 to start over. I think the databases files were running out of a old, improperly named folder.
73,
Rod