Darrin,
Should the panafall mode function independent of the mode selection on RX1? Panafall on RX2 doesn't function unless panafall is selected on RX1 at the same time. I also noticed when RX1 is in waterfall mode and RX2 is in panadapter mode, the RX2 display is jerky. Do I have something set up incorrectly?
Thank you - Jerry
Panafall mode on RX2
-
ke9ns
- Site Admin
- Posts: 524
- Joined: Mon Nov 05, 2018 9:38 am
- Location: Illinois, North West Suburbs
- Contact:
Re: Panafall mode on RX2
Jerry,
The jerky motion is because of the setup->General->Hardware Config->DttSP auto restart checkbox is ON.
The DttSP setting needs the Panadapter to be ON. I fixed the code with v2.8.0.109
I dont recall if I was expecting Panafall on RX1 before enabling Panafall on RX2 (its been too long to remember)?
I thought I had them independent, but I will take a look.
Thanks
Darrin ke9ns
The jerky motion is because of the setup->General->Hardware Config->DttSP auto restart checkbox is ON.
The DttSP setting needs the Panadapter to be ON. I fixed the code with v2.8.0.109
I dont recall if I was expecting Panafall on RX1 before enabling Panafall on RX2 (its been too long to remember)?
I thought I had them independent, but I will take a look.
Thanks
Darrin ke9ns
Creator of PowerSDR KE9NS v2.8, based on the Flex Radio PowerSDR v2.7.2 software.
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior