"Out of Band" below VFO Frequency

[pwest]

Hello all:
Yesterday when I fired up PowerSDR )(with my Flex-1500), it complained that the database was corrupted. I let it load the last good copy, and all seems fine except the band indicator below the VFO frequency always (at least for all bands/freqs I've tried) now indicates "Out of Band". I tried to use the 'repair' function of the installer but this seemingly had no impact.

Any ideas for getting this fixed would be appreciated!

Thanks,
Phil

[ke9ns]

Take a photo of the full PowerSDR console when this happens, so I can see everything.
Darrin

[pwest]

Here's a pic. I've tried changing bands and scanning around within bands, but 'Out of Band' persists. Otherwise all is working well (as usual).

PowerSDR_OutOfBand.PNG (1.27 MiB) Viewed 22308 times

Thanks,
Phil

[ke9ns]

Try doing setup->factory defaults.
Then see if it clears up before trying to put back a "backup"

Darrin

[pwest]

This worked!

Many thanks,
Phil