Fatal Error Value of -206
Fatal Error Value of -206
When I try loading Powersdr V 2.8.0.325 I get this Error. Says Fatal Error Value of -206 Value should be between minimum and maximum. It happened using version 2.8.0.317. I tried just updating to the newest version to see if it might fix it. It didnt I get same Message. Any ideas what I can do to fix this. Or do I need to uninstall everything and start fresh. Any help Appreciated. Thanks
-
ke9ns
- Site Admin
- Posts: 624
- Joined: Mon Nov 05, 2018 9:38 am
- Location: Illinois, North West Suburbs
- Contact:
Re: Fatal Error Value of -206
Either you would need to go into your database file and correct the value based on the item it says as an out of bounds value, or force a factory defaults reset.
If you hold down the SHIFT key, then right click on the PowerSDR icon and click OPEN, keep holding down the SHIFT until PowerSDR asks if you want to reset the database.
If you have made a backup of your database, you can try importing it back in when PowerSDR comes up.
Otherwise you will need to setup everything over again.
Darrin
If you hold down the SHIFT key, then right click on the PowerSDR icon and click OPEN, keep holding down the SHIFT until PowerSDR asks if you want to reset the database.
If you have made a backup of your database, you can try importing it back in when PowerSDR comes up.
Otherwise you will need to setup everything over again.
Darrin
Creator of PowerSDR KE9NS v2.8, based on the Flex Radio PowerSDR v2.7.2 software.
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior
Flex-5000, LDMOS and Titan Amps, G5RV, and Mosley TA-33 Junior